Hi,

We have used Jenkins plugin for qTest for some time now and now (I don't since when though) I can't select a container to post into.

I can select new ones, either existing release or existing container, it always come back to a default one (I still can't figure out how it is chosen) when saving job changes. So results are not posted in the correct selected container.

I have just created a new job and linked with our qTest instance:

• create new job
• configure tests to be run (FitNesse in our case)
• publish JUnit tests results
• post to qTest
  • select existing container (not release)
  • check the box to create a daily suite
  • link with tests cases by "method" (each test will have a test run)
• save
• then come back in configuration : default release container is selected, not the one I selected above

Then when executing the job, the data seems to be posted in the correct container, but the configuration in Jenkins configuration is still wrong.

I didn't try again with the initial job when we saw the issue because it is running for at least 7 hours and executing a lot of tests against our hardware, so it will be difficult to have a feedback on this one.

Thanks